First, before the electronic jacquard machine is repaired, you should first press the left and right two red buttons, these two red buttons can help the equipment stop, and display the equipment is being repaired and processed. In this way, other idle people will not be close to the equipment during the repair process.
Second, in the process of electronic jacquard machine maintenance, relevant maintenance personnel and staff cannot cross the guardrail. If you need to go up and down stairs for use or maintenance, you also need to be slow and careful to avoid falls and slips.
Third, for the equipment used in the relevant grain plate across the bridge cross stick disassembled, remember not to hang the gantry on the ground at will, so that it is easy to roll off. This in turn injures equipment and related staff.
Fourth, for the maintenance and use of electronic jacquard machines, related tools can not be placed at will, which can easily cause falls and cause damage to staff or equipment. Serious may even cause certain safety accidents.
Fifth, if the electronic jacquard machine needs the safety baffle of the mobile device when it is repaired, then after the maintenance procedure is over, the safety baffle must be restored to its original position.
Sixth, after the maintenance of the electronic jacquard machine, the slow car runs more than 2 latitudes, and the maintenance personnel determine that the equipment has been able to operate normally, and then take the fast car to run. It is then determined whether the jacquard effect of the relevant textile fabric meets the standard.