Special instructions for jacquard lace machine

1) Amplitude display:
Its function refers to whether the resonance between the ultrasonic oscillator and the steel mold is suitable. Rotate the sonic adjustment knob to change the reading. Generally adjusted below 50.
2) Ammeter:
Indicates the operating current of ultrasound. When no-load, it indicates the state of resonance between the sonotrode and the system, generally normal is 0.4~0.6A, depending on the size of the output power, when loaded, depending on the pressing area and the flower wheel and complex, the size is usually 1.0~2.5A.
3) Power output:
Adjust the output power to different file bits, and the ammeter reading will change.
4) Moulding speed:
Adjust the rotational speed of the flower wheel. The higher the number, the faster the speed; Conversely, the speed decreases.
5) Lower mold speed:
Adjust the speed of the ultrasonic steel mold. The larger the digit, the faster the speed; Conversely, the speed decreases.
6) Manual/automatic switch:
When the automatic gear is hit, the flower wheel and steel mold run automatically; Hit the manual switch, the operation of the flower wheel and steel mold is controlled by the foot pedal of the right foot, step down the foot pedal flower wheel and steel mold to start working, release the foot pedal flower wheel and steel mold to stop running.
7) Overload indication:
The red indicator lights up, indicating that the device is overloaded. At this point, you should stop the machine immediately, check the cause and troubleshoot before continuing to work.
8) Sonic adjustment:
Adjust the resonant state between the ultrasonic vibrator and the steel mold. Turn the knob clockwise or counterclockwise and the amplitude meter reading will change, as mentioned earlier, and the normal reading is generally within 50.